Loading ...
Loading ...
Loading ...
Hand Alignment
Adjustment
Strong magnetism or impact can cause the
time indicated by the analog hands to become
different from the time on the display. If this
happens, adjust hand alignment.
Using the CASIO WATCHES
Phone App to Adjust Hand
Alignment
If the watch is paired with a phone, you can
also use CASIO WATCHES to adjust hand
alignment.
l
Adjusting Hand Alignment
Adjusting Hand Alignment
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Loosen the crown and then pull it out.
The currently selected Home City will
appear on the display.
●
This causes the second hand to move
to 12 o’clock.
Crown
Home City
3. Hold down (A) for at least five seconds.
Release the button when [HAND SET]
appears on the display and the second
hand completes one full rotation.
[HAND ADJ] flashes, and hour, minute,
and second hand auto calibration starts.
●
After auto alignment is complete, the
hands should be in the positions shown
below.
Hour handMinute hand
Second hand
4.
Press (C).
This enables adjustment of the bearing
hand alignment.
Bearing hand
5. If the bearing hand is not aligned with 12
o’clock, rotate the crown to align it
correctly.
6. Press (C).
This enables adjustment of the function
hand alignment.
Function hand
7. If the function hand is not aligned with 12
o’clock, rotate the crown to align it
correctly.
8. Push the crown back in and then lock it.
This returns the hands to normal
timekeeping.
Note
●
If you do not perform any operation for
about two minutes after pulling out the
crown, crown operations will
automatically become disabled. If that
happens, push the crown back in and
then pull it out again.
Important!
●
After hand position adjustment is
complete, check to make sure that the
proper time is being indicated by the
hands in the Timekeeping Mode and
on the display. If the hands are
misaligned, perform steps 2 through 8
again.
Other Settings
This section explains other watch settings you
can configure.
Enabling the Button
Operation Tone
Use the procedure below to enable or disable
the tone that sounds when you press a button.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Loosen the crown and then pull it out.
The currently selected Home City will
appear on the display.
Crown
Home City
3. Press (B) twice.
This causes [KEY♪] or [MUTE] to flash on
the display.
4. Rotate the crown to select either [KEY♪]
or [MUTE].
[KEY♪]: Operation tone enabled.
[MUTE]: Operation tone muted.
5. Push the crown back in and then lock it.
Watch Operation Guide 5713
48
Loading ...
Loading ...
Loading ...