Loading ...
Loading ...
Loading ...
●
Power Saving Function
Leaving the watch in a dark location for about
one hour between the hours of 10 p.m. and
5:50 a.m. will cause the display to go blank
and then the watch will enter Level 1 power
saving. If the watch is left in this condition for
six or seven days, it will then enter Level 2
power saving.
Power Saving Level 1 :
The second hand stops at 12 o’clock and the
digital display goes blank to save power. The
watch can connect with a phone at this level.
Power Saving Level 2 :
All hands stop and the digital display goes
blank to save power. All functions are
disabled.
Recovering from Power Saving Operation
Use one of the operations below to exit power
saving.
●
Press any button.
●
Move the watch to a bright location.
●
Trigger auto light by angling the watch
towards your face.
Note
●
The watch will not enter power saving
in the cases below.
ー
While in the Stopwatch Mode
ー
While in the Timer Mode
ー
While the barometric pressure
change indicator is displayed
●
You can enable or disable Power
Saving.
l
Configuring Power Saving
Function Settings
●
Note that the watch also may enter
power saving if its face is blocked from
light by your sleeve while you are
wearing it.
Viewing the Face in the Dark
The face of the watch can be illuminated for
viewing in the dark.
●
To illuminate the face manually
Press (E) to turn on illumination.
●
Illumination turns off automatically if an
alarm starts to sound or if you perform a
crown operation.
●
Illumination does not turn on while a signal
receive operation or a hand movement
operation is in progress. Also, illumination
may not turn on while a sensor is taking a
reading.
●
To illuminate the face when Auto Light
is enabled
If Auto Light is enabled, face illumination will
turn on automatically whenever the watch is
positioned at an angle of 40 degrees or more.
40
degrees
or more
Important!
●
Auto Light may not operate properly
when the watch is at a horizontal angle
of 15 degrees or greater from
horizontal as shown in the illustration
below.
●
Electro-static charge or magnetism
can interfere with proper auto light
operation. If this happens, try lowering
your arm and then angle it towards
your face again.
●
When moving the watch you may note
a slight rattling sound. This is due to
operation of the auto light switch,
which determines the current
orientation of the watch. It does not
indicate malfunction.
Note
●
Auto Light is disabled when any one of
the conditions below exists.
ー
Alarm, timer alert, or other beeper
sounding
ー
Hand movement operation is in
progress
ー
Watch in the Compass Mode
ー
While a time signal receive
operation is in progress
●
Configuring the Auto Light Setting
You can enable or disable Auto Light as
required.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Loosen the crown and then pull it out.
The currently selected Home City will
appear on the display.
Crown
Home City
3. Press (B) three times.
[ ] appears on the display with
[ON] or [OFF] flashing.
4. Rotate the crown to enable or disable the
Auto Light.
5. Push the crown back in and then lock it.
Note
●
If you do not perform any operation for
about two minutes after pulling out the
crown, crown operations will
automatically become disabled. If that
happens, push the crown back in and
then pull it out again.
Watch Operation Guide 5713
13
Loading ...
Loading ...
Loading ...