Loading ...
Loading ...
Loading ...
46
4.4.3 PPPoE
Point-to-Point Protocol over Ethernet, is one of the protocols that device uses to connect to the
internet. Get the PPPoE username and password from the internet service provider, and then set up
network connection through PPPoE, the camera will acquire a WAN dynamic IP address.
Prerequisites
●
The camera has connected to the network.
●
You have gotten the account and password from Internet Service Provider.
Procedure
Step 1 Select >
Network
>
PPPoE
.
Step 2 Click , and then enter username and password.
●
Disable UPnP while using PPPoE to avoid possible influence.
●
After making PPPoE connection, the device IP address cannot be modified through
web page
Figure 4-26 PPPoE
Step 3 Click
Apply
.
The success prompt box is displayed, and then the real-time WAN IP address is displayed.
You can visit camera through the IP address.
4.4.4 DDNS
Properly configure DDNS, and then the domain name on the DNS server matches your IP address
and the matching relation refreshes in real time. You can always visit the camera with the same
domain name no matter how the IP address changes.
Prerequisites
Check the type of DNS server supported by the camera.
Step 1 Select >
Network
>
DDNS
.
●
Third party server might collect your device information after DDNS is enabled.
●
Register and log in to the DDNS website, and then you can view the information of all
the connected devices in your account.
Step 2 Click to enable the function.
Loading ...
Loading ...
Loading ...