Loading ...
Loading ...
Loading ...
11
Parameter Description
ARP/Ping
Click to enable ARP/Ping to set IP address service. Get the
camera MAC address, and then you can change and configure the
device IP address with ARP/ping command.
This is enabled by default. During restart, you will have no more than
2 minutes to configure the device IP address by a ping packet with
certain length, the server will be turned off in 2 minutes, or it will be
turned off immediately after the IP address is successfully configured.
If this is not enabled, the IP address cannot be configured with ping
packet.
A demonstration of configuring IP address with ARP/Ping.
1. Keep the camera that needs to be configured and the PC within
the same local network, and then get a usable IP address.
2. Get the MAC address of the camera from device label.
3. Open command editor on the PC and enter the following
command.
4. Restart the camera.
5. Check the PC command line, if information such as
Reply from
192.168.0.125…
is displayed, the configuration succeeds, and
you can turn it off then.
6. Enter http://(IP address) in the browser address bar to log in.
NIC
Select the Ethernet card that need to be configured, and the default
one is
Wire
.
Mode
The mode that the camera gets IP:
●
Static
Configure
IP Address
,
Subnet Mask
, and
Default Gateway
manually, and then click
Save
, the login page with the configured
IP address is displayed.
●
DHCP
When there is DHCP server in the network, select
DHCP
, and the
camera acquires IP address automatically.
Loading ...
Loading ...
Loading ...