Loading ...
Loading ...
Loading ...
14 www.senixtools.com
The wheels can be adjusted to two positions.
1. Pull on the wheel and move it to required position,
let go of the wheel and make sure it locks in position
(Fig. 7).
WARNING:
The wheels can be adjusted in two different positions.
Always ensure the wheels are securely locked! Do not
attempt to use the product with the wheels in any other
position or unlocked!
1
2
Fig. 7
1 Working
2 Transport
STARTING INSTRUCTIONS
1. When oil level is full, the oil will be between the up-
per limit and lower limit on the dipstick. If oil level is
below the lower limit, add oil until the fluid level rises
between the upper limit and lower limit on the dips-
tick. Reinstall the oil fill plug. (Fig. 5)
2. Fill the fuel tank. Stop adding the fuel when you see
that the level reaches the base of the tank spout.
3. Slowly press and release the primer bulb 10 times
(Fig. 8).
4. Push the choke button in until it clicks (Fig. 9).
NOTE: The choke automatically disengages when the
throttle lever is squeezed.
5. Pull the starter rope with a controlled and steady mo-
tion five times until engine starts or attempts to start
(Fig. 10).
6. Squeeze the throttle lever to release the choke but-
ton (Fig. 11).
IF.. the unit fails to start. Squeeze the throttle control,
and pull the starter rope until the engine starts.
IF THE ENGINE IS HOT... begin the starting procedure
with step 5.
STOPPING INSTRUCTIONS
1. Release the throttle lever and allow the engine to
idle.
2. Press and hold the On/Off switch in the Off (O) posi-
tion until the engine comes to a complete stop
OPERATION
(Fig. 12). Make sure the cutting attachment has stop-
ped before the unit is set down.
NOTE: This OFF switch will come back to the ON posi-
tion automatically.
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Loading ...
Loading ...
Loading ...