B160-001-CSI Owner's Manual

Loading ...

Point-to-Multipoint Installation –

Managed Switch with IGMP

1. Ensure all equipment to be connected is powered off.

2. Connect the audio/video source to the transmitter unit’s input port

(see Optional Accessories for available Tripp Lite audio/video cables).

3. (Optional) Connect the computer’s DB9 port to the transmitter unit’s

serial port. Depending on the model, the serial port will be either DB9 or

3.5 mm. Models with 3.5 mm jacks include a 3.5 mm to DB9 adapter.

Models with DB9 ports require standard RS-232 DB9 cable (sold

separately) for connecting to a computer.

4. (Optional) Connect the included IR-OUT cable to the transmitter unit’s

IR-OUT port. Place the sensor and cable in an unobstructed area within

clear view of the device being controlled.

Note: The IR-OUT cable receives the signal from the remote control and sends it

to the device being controlled (e.g. Blu-ray player, etc.).

5. (Optional) Using an HDMI cable, connect a local monitor to the

transmitter unit’s HDMI output port (see Optional Accessories for

available Tripp Lite HDMI cables).

6. Set the Channel Number (0 to 63 are available) on the front of the

transmitter to a desired number by pressing the Up / Down buttons. This

number MUST be the same on all transmitter and receiver units in the

installation. If you are using transmitter and receiver units that are all

brand new, they will default to Channel Number 0 and you can leave the

channel unchanged upon installation.

Note: A locking mechanism prevents the Channel Number from being

unintentionally changed. When the Channel Number is locked, hold down the Up

and Down buttons until the Channel Number starts blinking. Then navigate to the

desired Channel using the Up / Down buttons. Once the desired Channel Number

has been selected, lock the Channel Number by holding down the Up and Down

buttons until the Channel Number stops blinking.

7. Connect the RJ45 Output port on the transmitter unit to an RJ45 port

on the network switch using Cat5e/6 cable.

Note: The maximum allowable cable length from transmitter to switch is 328 ft.

(100 m).

Loading ...

Owner's Manual - Page 13