Loading ...
Loading ...
Installation instructions.
A_ CAUTION: Certain plumbing skills are needed for installation. If you are unsure about
any part of the installation of this product, consult a professional plumber.
Unpacking and Inspection
Be sure to check the entire softener for any
shii)ping damage or parts loss. Also note
(lamage to tile shii)ping cartons. Contact the
transportation company for all damage and
loss claims. The ii/antlf_lCttli'ei" is not
responsible fl)r damages in transit.
Small parts needed to install tile softener are
packaged either in a bag or on a cardboard
sheet. To avoid loss of the small parts, kee I)
them packaged tmtil you are ready to use them.
Be StlYe not to discard components hidden in
packaging.
Important Installation Recommendations
Read entire manual. Failure to follow all guidelines and rules could cause personal injury or
property damage.
_: Before you 1)egin installation, read these
Installation Instructions completely. Then,
obtain all tile materials and tools you will
need to make the installation. Failm'e to
properly install the softener voids the
W[I IT[I n IV.
Maximum allowable inlet water pressm'e is
195 psi. If daytime pressure is over 80 psi,
nighttime pressure may exceed tile
maximmn. Use a pressure reducing wflve
if necessary: (Adding a pressure reducing
wflve may reduce tile flow.)
::Ji::Check local codes. Tile installation m ust
conform to them.
::Ji::In the Commonwealth of Massachusetts,
Plumbing Code 248 CMR shall be adhered to.
Consult with your licensed plumber.
::J?::Use only lead-h'ee solder and flux for all
sweat-solder connections, as required bv
state and federal codes.
_: Connect tile soliener to tile main water
supply pipe before or ahead of the water
heater. DO NOT RUN HOT WATER THROUGH
THESOFTENER.Temperature of water
passing through tile softener illtlst be
less than 120°F.
::Ji::Tile softener works on 24 volt-60 Hz
electrical power only. Be sure to use tile
included transformer. Be sure tile electric
outlet and transformer are in an inside
location to protect ['l'OlIl i/loisttlre.
_: See Where to Install the Softener section fl)r
more derails.
A WARNING:Do use with water
that is microbiologically tmsafe or of
tmknown quali W without adequate
disinfection befi)re or atier the system,
The water should be tested periodically
to verif)' that tile system is peril)truing
satistactorilv.
_: Use care when handling tile softener.
Do not ttlFn upside down, drop, drag
OI" set on shay l) l)I'otI'/Isions.
_: Small parts remaining after tile installation
could be a choke hazard. Discard safely.
Loading ...
Loading ...
Loading ...