Loading ...
Loading ...
Loading ...
Step-by-step installation instructions.
Sanitizing Procedures
Tocomplete the installation, do the following
sanitizing procedures.
Care is taken at the factory to kee I) your
water sotiener clean and sanitary: Materials
used to make the sotiener will not infect or
contaminate vour water supply and will not
cause bacteria to t()i'ill OI" gI'oW, However,
during shipping, storage, installing and
operating, bacteria could get into the
softeuer. For this reason, sanitizing as
tollows is suggested when installing.
NOTE: Smfitizing is recommended by the
Water Quality Association for disinfecting.
I. Be sm'e to complete all installation steps,
including programming the control.
2. Pour about 3/4 oz. (1 ½ tablespoons) of
common 5.25% unscented household bleach
(Clorox, I,inco, Be Peel), White Sail, Eagle,
etc.) into the brinewell. Refer to illustration
on page 5.
3. IMPORTANT." Press and hold lot 3 seconds
the taceplate RECHARGE@ button to start
an immediate recharge. RECHARGEbegins
to flash in the displa> The bleach will be
drawn through the water softener, and out
the drain. This process rakes approximately
2 hours.
4. If, after sanitization, water fl'om the house
fimcet tastes salty or has a slight col(n; this is
a preservative ti'om the resin tank. Tm'n on
the cold sott water fimcets and drain tin" a
tew minutes or until clear.
NOTE:When the sanitizing recharge is ovex,
all remaining bleach is flushed from the
conditioner and veto" house COlD water supply
is hilly soft im m ediatel> However, yam" water
heater is filled with hard water and as hot water
is used, it will refill with soft water. When all the
hard water is replaced in the water heater, hot
only and mixed hot and cold water will be hilly
soil If you want totally salt water imm ediatel>
after the above recharge, drain the water heater
tmtil the water runs cold.
A WARNING:,,,,(),,dod,aiuthe
water heater, rise extreme care as the hot
water could catlse burus. Turu the water
heater off prior to draining.
Specifications/Dimensions
(;XSF27E
Rated Cat)acity* 11,100 grains with 2.2 lbs. oI sah
23,700 grains with 7.0 lbs. of salt
28,900 grains widl 11.7 lbs. of salt
Rated E/l]ciencv':* 5,070 grains!lb. @ 2.2 lbs. of salt
Amotmt of tligh Cat)acity Resin (lbs!cu./1) 38.0/0.73
Resin Tank Nominal Size (in., dia. x heigh0 8 x 40
Service Flow Rate (gt)m) 6.5
\rater Supply Maximmn IIardness (gpg) {)5
\rater Supply Maximmn Clear Water Iron (t)pm)':** 4
\rater Pressure 15mils (min.-max. psi)**** 20-125
Pressure Drop at Rated Service Iqow (psig) 11
Water Temt)eratm:e limits (min.-max. OF) 40-120
Maximum Flow Rate to Drain (glint) 2.0
These b}btems con[oll// to NSFiANSI 44 for the specific capacity claims as xs.rified and substantiated b_ test data.
* _l_sting was performed using pellet grade sadiron chlolide as the regene_ant salt.
** E_ciency rating is valid only at the lowest sta_d salt dosage. These softeners were e_cien(_ l_t_(1 acco_ling to
NSF/ANS144.
_'_"*: Extel/t of h'Oll rl.ml)\_ll ma} \_1 i_ith COllditil)ns. The _apa(ity to r(,t-hlce deal !_at(,l" ill)n is stlbstantiated 1)_
_'(_\ test data. State of Wis(onsin lequiles additional treatmellt if _att,r supply contains gl_atel" tha]l 5 ppm
(lear watel iron. [se of Diamond (;i _tal _ Red-()/It _o_ Stlper hen ()tit __dll implmv iron lenlo_al. Reler to
Cleaning Iron Out of the Water Softening System section.
***:*: Canada _o_;ing p_ essm'e limits: ] .4-7.0 kg/tm _.
10
477:"
3 3/8"
,NLETOOTLET/°-\
411/4" .,_._ 16"--_,-
i
Loading ...
Loading ...
Loading ...