Loading ...
IMPORTANTSAFETYINFORMATION.
READALLINSTRUCTIONSBEFOREUSING.
WARNING!
For your safety, the information in this manual must be followed to minimize the risk of electric shock,
property damage or personal injury.
SAFETYPRECAUtiONS
_: Check and cmnl)ly with vour state and local
codes. You must tollow ti/ese guidelines.
::Ji::Use care when handling the water softening
s_:stem. Do not turn upside down, drop, drag
or set on sharp protrusions.
?_:Water softening systems using sodimn chloride
(salt) for recharge add sodium to the water:
Persons on sodium restricted diets should consider
the added sodium as part of their overafl intake.
Potassium chloride can be used as an alternative
to sodium chloride in your softener
The _ater softening system _orks on 24 xolt-60 Hz
electrical power only. Be sure to use only the
included transformer
_: Use clean water softening salts only, at least
99.5% pm'e. NUGGET, PEI,I,ET or coarse
SOLAR salts are recommended. Do not use rock,
block, granulated or ice cream making salts.
They contain dirt and sediments, or mush and
cake, and will create maintenance problems.
::Ji::Keep the salt hole cover in place on the softener
tmless servicing the trait or refilling with salt.
A WARNING:oo.o, use with water that is
microbiologically unsati _ or of unknown quality
without adequate disinfection befi)re or after
the system.
iJi::Transformer must be )luo,_ed into indoor
120 xolt, grotmded outlet only.
PROPERINSTALLAtiON
This water softening system must be properly installed and located in accordance with the Installation
Instructions before it is used.
_: Install or store where it will not be exposed to
temperatures beh)w fl'eezing or exposed to any
type of weather: Water fi'eezing in the system will
break it. Do not attempt to treat water over 100°E
::Ji::Do n0tinstall in direct sunlight. Excessive sun or
heat may cause distortion or other damage to
non-metallic parts.
Properly ground to cent)tin with all governing
codes and ordinances.
Use only lead-free solder and flux for all sweat-
solder connections, as required by state and
federal codes.
_: Softener resins may degrade in the presence
of chlorine above 1 ppm. If you have chlorine
in excess of this ainount, you inay experience
reduced life of the resin. In these conditions,
you may wish to consider pro'chasing a (;E
point-ofent_ T household filtration system with
a chlorine reducing filte_:
A WARNING:Disc.,-d.lluilusedpax'ts
and packaging material alter installation.
Small parts remaining after the installation
could be a choke hazard.
Tile water softening s}:stem requires a minimum
water flow of three galhms per minute at the inlet.
Maximum allowable inlet water pressm'e is 125 psi.
]f daytime pressm'e is over 80 psi, nighttime
pressm'e may exceed the maximmn. Use a pressm'e
reducing \:dye to reduce the flow if necessarx:
READANDFOLLOWTHISSAFETYINFORMAtiONCAREFULLY.
SAVETHESEINSTRUCTIONS
2
Loading ...
Loading ...
Loading ...