Loading ...
Loading ...
Loading ...
In the case of the faders, encoders, and the Select buttons, the display contains an
additional field.
For these controls the top row of the display shows which control is being used, which of
the three control banks is currently selected, and the value of the data being sent, and then
is shows the MIDI channel assignment and the data type being sent.
5.4. Controller bank selection
The control buttons on the left side of this graphic are used to select which of the three banks
of encoders, faders, and buttons are being accessed from the front panel. The appropriate
button will be lit to indicate which bank is active.
5.5. Program Change messages
While in User mode, Category, Preset, Center Knob, and Left/Right Arrows can be used to
send program change messages to hardware or software instruments.
When you press the Category or Preset button, you will see "Bank Nbr" on the upper line and
"Prog Nbr" on the lower line of the display.
Pressing the Category button selects the Bank number field, while pressing the Preset button
selects the Program number field. Use the Center Knob to scroll through different banks and
programs. When ready to send the program change message, press down on the knob.
Alternatively, you can use the Left/Right Arrows to choose a bank or program. The only
difference here is that the program change is sent immediately as you press the arrows;
when using the Center Knob the program change is only sent when you press down on the
knob.
User Edit mode: Encoder 1, Bank 1 selected
Arturia - User Manual KeyLab MkII - User mode 46
Loading ...
Loading ...
Loading ...