Loading ...
Loading ...
Loading ...
Transportation
The machine should be transported in an upright position.
NOTE! Always move tho welding machine by lifting it from tho handle.
Never pull it from the welding gun or other cables.
Environment
The machine is suitable for both indoor and outdoor use but it should be protected
from heavy rain and sunshine. Store the machine in a dry and clean environment
and protect it from sand and dust during use and storage. The recommended
operating temperature range is -20°C - +40°C (-4°F - +104°F). Place the machine in
such a way that it does not come in contact with hot surfaces, sparks and spatters.
Make sure the air ow in the machine is unrestricted.
GENERAL VIEW OF THE MACHINE
SETTING UP THE WELD
1. Make practice welds on pieces of scrap the same thickness as your intended
workpiece to practice the technique before welding anything of value.
2. Clean the weld surfaces thoroughly with a wire brush or angle grinder; there must
be no rust, paint, oil, or other materials on the weld surfaces, only bare metal.
3. Use clamps (not included) to hold the workpieces in position so that you can
concentrate on proper welding techniques. The distance (if any) between the two
workpieces must be controlled properly to allow the weld to hold both sides
securely while allowing the weld to penetrate fully into the joint. The edges of
thicker workpieces may need to be chamfered (or beveled) to allow proper weld
penetration.
4. Clamp Ground Cable to bare metal on the workpiece near the weld area, or to
the metal workbench where the workpiece is clamped.
www.SereneLifeHome.com
7
Loading ...
Loading ...
Loading ...