Loading ...
Loading ...
Loading ...
3. Once you have done, open the valve on the tank. You'll see the gauge on the
upper right and it'll swing way up and will show you in pounds per square inch
and how much gas is in the cylinder. If it's full, it'll swing way up.
4. Turn the machine on and ip the power switch on then reach over and grab your
gun next. Hold the big gun and don't worry about the wire coming out. Look
down at the gauge that you had set and pull the trigger on the MIG gun. You will
notice a depth and reach over the little brass T-handle, turn it in a little bit more
so that when you hit the trigger, it'll stay in your desired range.
5. When everything is set up and you have your gas set, grab your helmet, clip MIG
wire with MIG pliers cutting. Cut the wire as you desired and get ready to weld.
HOW TO ADJUST SETTINGS
FILLER WIRE
The machine is delivered with the welding gun connected to +pole making it
suitable for steel solid wire welding without adjustments.
WIRE FEED ROLL CHANGE
1. Open the pressure control rod.
2. Lift up the feed gear.
3. Turn the black knob clockwise 90°, remove the wire feeder.
4. Change the wire feeder or choose the right wire feeding trough, and then install
the new wire feeder.
www.SereneLifeHome.com
11
MIG Gun Nozzle Size
Inside Diameter
Minimum Current
Matching Flow
Typical Flow
Setting
Maximum Current
Matching Flow
0.03” (For access on
small welders)
50CFH 50-160CFH ~200CFH
2
1
43
Loading ...
Loading ...
Loading ...