Loading ...
Loading ...
Loading ...
www.SereneLifeHome.com
12
THREADING THE FILLER WIRE
1. Open the door, install the welding wire.
2. Release the wire and hold it in hand.
3. Cut out the curve part.
4. Open the pressure control rod, then
open the feed gear.
5. Feed the wire through the guide apparatus.
6. Close the feed gear and pressure control rod, make sure the wire feeds well.
7. Adjust the pressure to a suitable position.
Notice: if the pressure is too high, it will damage the wire; if the pressure is too
low, the feed gear will slip, wire will not work properly.
9. Press the welding gun trigger and wait for the wire to come out.
10. Close the reel housing cover.
CAUTION!
When driving the wire in to the gun, do not point the gun at yourself or others. For
example, your hand in front of the tip, because the cut wire end is extremely sharp.
Also, do not put your ngers near the feed rolls, bacause they might get squeezed
between the rolls.
REVERSING POLARITY
Some ller wires are recommended to be welded with the gun in the pole so the
polarity should be reversed. Check the recommended polarity from the ller wire
package.
Reversing polarity
Loading ...
Loading ...
Loading ...