Loading ...
Loading ...
Loading ...
11
InstallingtheFeet
1. Raise the end of the generator where the recoil starter is
located high enough to gain access to the frame bottom.
2. Align the bolts and the holes on the feet with the holes on
the generator frame. Insert the bolts through the holes so
they go through the frame. Secure the assembly with the
nuts (Fig. 3).
3. Repeat the above operation for the other foot.
InstallingtheWheels
Wheels are provided to assist in moving the generator to the
desired location and should be installed on the side where the
handle is located.
1. Raise the end of the generator where the handle is located
high enough to gain access to the frame bottom.
2. Slide the wheel axle through the hole in the center of the
wheel. Slide a washer onto the axle, then slide the axle
into the wheel mounting hole as shown. Fix the assembly
with the nut. Tighten to secure (Fig. 4).
3. Insert the 4 tabs on the S cover into the slots on the
wheel. Push rmly to secure (Fig. 5)
4. Repeat the above instructions for the other wheel.
LockingtheHandle
1. Insert the lock pin through the hole in the handle. Do not
insert fully (Fig. 6). Insert only enough to ensure the pin
threads do not extend inside the handle frame, as shown.
2. Holding the lock pin in place, use a wrench to turn the nut
on the lock pin clockwise to secure (Fig. 7).
3. To extend the handle, pull the lock pin ring to unlock
the handle, and turn the handle up to the transporting
position. Release the ring to lock the handle in place. To
Fig.3
Bolts
Feet
Nuts
Fig.4
Wheel
Washer
Nut
Wheel axle
Fig.5
Wheel
cover
Tabs
(4total,2ontheotherside)
Handle lock pin
Fig.6
Threads pass
the hole
Handle lock pin
Fig.7
Lock pin nut
Loading ...
Loading ...
Loading ...