Loading ...
Loading ...
Loading ...
Cleaning and care
93
Carrying out the descaling process
Select Further.
Select Maintenance.
Select Descale.
If the operating modes and automatic
programmes with moisture are already
disabled, the descaling process can
be started immediately by touching
OK.
Push the universal tray into the top
shelf level as far as it will go to collect
the descaling agent after it has been
used. Confirm the message shown
with OK.
Attach one end of the plastic tube to
the water intake pipe.
Place the container with the
descaling agent on the floor of the
oven.
Place the other end of the plastic
tube in the bottom of the descaling
agent container and secure the
plastic tube to the container with the
suction cup.
Confirm with OK.
The water intake process will begin. You
will hear the noise of the pump.
You can interrupt and resume the
intake process at any time by
selecting OK.
A message will appear when the intake
process is finished.
Confirm with OK.
Provide 1l of fresh water and follow
the instructions in the display.
The activation phase will begin. You
can follow the time counting down in
the display.
Leave the container with the tube
connected to the water intake pipe in
the oven compartment.
The system will take in liquid several
times during the activation phase. You
will hear the noise of the pump.
The oven interior lighting and cooling
fan remain switched on for the whole
duration of the process.
At the end of the activation phase, a
buzzer will sound.
Rinsing the steam injection system
after the activation phase
After the activation phase, the steam
injection system must be rinsed out
with cold fresh water to remove
residues of descaling agent.
To do this, approx.1litre of fresh water
is pumped through the steam injection
system three times and is collected in
the universal tray.
Rinse the container thoroughly after
the first rinse to remove any descaling
agent residue.
Follow the instructions in the display.
Loading ...
Loading ...
Loading ...