Loading ...
Loading ...
Loading ...
109
4. Before First Use4. Before First Use
Ensure all packaging has been removed.
Ensure the espresso machine is always positioned onto a dry, stable, flat
horizontal counter top.
Step 1 - Please make sure that the rubber plug of the
water outlet of the water tank is removed.
Step 2 - Extract the tank by pulling it upwards.
Step 4
Step 3
affect the coffee effect.
Step 4 - Set up the water tank vertically and align the buckles
to the hole on the back of the machine, and then press it
down to be parallel to the top of the machine.
Step 1 - The steam/water knob is in a horizontal position (off-position).
Step 2 - Insert the Power Plug into a 120V AC power outlet & switch the power
on.
Step 3 - Press the ON/OFF button to turn on the
machine.
- The ON/OFF button will illuminate & pulse to
indicate the machine is heating up.
- When the 4 buttons are solid on, the machine is in the
READY state for all features.
Step 1 - Align the marking dot on the filter with the
portafilter's groove, and then install the filter to the
portafilter, twist and fix the filter.
Step 2 - Hold the machine with one hand and the
portafilter with the other hand.
Step 3 - Place the portafilter underneath the group head
so that the handle is aligned with the INSERT position.
Insert the portafilter into the group head and rotate the
handle towards the center until resistance is felt.
Wash the parts listed below in warm water:
- Stainless Steel Single Cup Filter - Portafilter
- Stainless Steel Double Cup Filter - Drip Tray
- Removable Water Tank - Spoon & Tamper
Rinse & allow thorough air drying.
Do not clean or soak the portafilter in any descaling solution, otherwise,
it would be damaged.
NOTE
Turning the Portafilter to the centre position might be tight for the first
few uses.
NOTE
More simply, the water tank can also be filled without
being extracted by pouring the water directly from a jug.
NOTE
This priming step must be completed prior to first use.
IMPORTANT
4.1 Remove Packaging
4.2 Position Machine
4.3 Wash & Dry Parts
4.4 Prime the Machine
• Fill Water Tank
• Power
• Insert Portafilter
CENTRE
1.ALIGN
& INSERT
CENTRE
INSERT
2.TURN
Step 3 - Open the lid and fill enough pure water(recommended) in advance
but not exceed the MAX line of the water tank, and do not add too little water,
otherwise when the water runs out the water pump will make a loud noise and
Step 1
Loading ...
Loading ...
Loading ...