Loading ...
Loading ...
Loading ...
Installation Instructions
IT] ADJUST BROIL AND OVEN
BURNER AIR ADJUSTMENT
SHUTTERS IF NECESSARY
Air adjustment shutters for the top and bottom burners
regulate the flow of air to the flames.
The air adjustment shutter for the top (broil) burner is
in the center of the rear wall of the oven.
ustment
shutter
I
The shutter %r the bottom (oven) burner is near the back
wall behind the warming drawe_; storage drawer or kick
panel. Remove the drawer or panel. See the Careand
cleaningof therange section.
To adjust the flow of air to either burner, loosen the
Phillips head screw and rotate the shutter toward open
or closed position as needed.
The fl_unes for the top (broil) burner should be steady
with approximately 1" blue cones and should not extend
out over the edges of the burner baffle.
To determine if the bottom burner flames are burning
properly, remove the oven bottom. Flames should have
approximamly 1" blue cones and, if range is supplied
with natural gas, should burn with no yellow tipping.
(With most LP gas, small yellow tips at the end of oumr
cones are hernial.) Flames should not lift off"burner
ports. If lifting is observed, gradually reduce air shutmr
opening until flames are stabilized.
44
IT1 ADJUST BROIL AND OVEN
BURNER AIR ADJUSTMENT
SHUTTERS IF NECESSARY (CONT.)
Oven bottom
To remove the oven bottom:
A. Remove the screws holding down rear of the oven
bottom.
B. Grasp the oven bottom at finger slots on each side.
C. Lift the rear of the oven bottom enough to clear the
lip of the range flvmle, push it back, and then pull it
up and out.
I-8-1LEVELING THE RANGE
A. Install the oven sheh'es in the oven and position the
range where it _11 be installed.
Raise
_1 _ range Lower
Lower range
, _ _ range
Leg _
leveler--"'_
Raise_"_
range_
(on some models) (on some models)
B.
Check for levelness by placing a spirit level or a cup,
partially flled with wam_, on one of the oven shelves.
If using a spirit level, rake two readings---with the level
placed diagonally first in one direction and then
the ethel
C.
D.
t.
Remove the storage drawer or kick panel. See die Care
and cleaning of the range section. The fiont leveling legs
can be adjusmd flom the bottom and the rear legs can
be adjusted flom the mp or the bottom.
Use an open-end or adjustable wrench to adjust the
leveling legs undl the range is level.
At_er the range is level, slide the range away flom the
wall so that the And-Tip device can be installed.
Loading ...
Loading ...
Loading ...