Loading ...
Loading ...
Loading ...
E E E E E E E E E E E E E E E E E E
E E E E E E E E E E E E E E E E E E
26E
TROUBLESHOOTING
BEFORE YOU CALL
COOKTOP
PROBLEM SOLUTION
Part of all of the appliance does not
operate
The appliance may be disconnected from the power source. If the Control Panel Display is
not illuminated or does not respond to manual commands, check the following:
• Power is connected at the circuit breaker
• The fuse is still functional and not blown
• The power cord is properly plugged in to a functional outlet
Radiant heaters too hot or not hot
enough
Improper cookware: Only use pans with at bottoms that match the diameter of the cooktop
burner in use. Large pots and pans can lose signicant heat from the top. Cover pans with
a lid to retain heat better.
Radiant heater stops glowing This is normal when radiant heaters are set to low heat settings.
Cooktop produces a strong odor or
light smoke when turned on
This is normal during the rst few uses and will cease after a few initial uses. Ventilate the
room to remove odors.
Areas of discoloration on cooktop
surface
Always clean food spills before the next use to avoid discoloration. See page 23.
Metal marks on cooktop surface Do not slide metal cookware on the cooktop surface. See page 23.
Brown streaks or specks on cooktop
surface
Always clean boil-overs before the next use to avoid streaks or specks. See page 23.
OVEN
PROBLEM SOLUTION
Strong odor during initial use of new
oven
This is normal and will disappear after one or two uses. To be careful, ensure all packag-
ing has been removed from the appliance and check around door sides and inside drawer.
Control Panel Display is dark and
unresponsive
If the Control Panel Display shows only ] or ] [, the appliance is in Sabbath mode. See
page 12.
Control Panel Display is illuminated
but unresponsive
Control Lock may be activated. Touch and hold Control Lock pad for 3 seconds to unlock.
Alternatively, disconnect and reconnect power at the circuit breaker to reset.
Oven door is locked and will not open If a Self Clean cycle has recently nished, this is normal. Wait for the oven to cool fully,
then it will unlock.
Door will not close properly Door is not installed properly. See page 25.
Drawer will not close properly Drawer is not installed properly. See page 25.
Oven taking too long to cook Adjust the oven calibration. See page 11.
Food is overcooked Adjust the oven calibration. See page 11.
Food is not baking evenly Ensure racks are in the correct position. See page 18.
Oven light is not working
1 Oven light bulb may be burned out and need replacing. See page 24.
2 If the Control Panel Display shows only ] or ] [, the appliance is in Sabbath Mode. See
page 12.
Oven will not start Self Clean cycle If the oven was recently used or the cooktop is currently in use, this is normal. Self Clean
can only be initiated when the oven is cool and the cooktop is not in operation.
Metal popping sounds during Self
Clean cycle
This is normal.
Loading ...
Loading ...