Loading ...
Loading ...
Loading ...
STAGEPAS 100BTR, STAGEPAS 100 Owner’s Manual
11
Getting sound out of the
speaker
1 Make sure that the power to the STAGEPAS
100 is turned off (the [POWER] LED is
turned off).
2 Turn the [LEVEL] controls to the minimum
(zero).
3 Set the [EQ] controls to the center (•)
position.
4 Set the [MIC/LINE] switch to the MIC (N)
position for channels to which a
microphone is connected. Set the [MIC/
LINE] switch to the LINE (O) position for
channels to which a musical instrument or
audio device is connected.
5 Turn on the power to the connected
musical instrument or audio device, then
press and hold down the [P] (Power)
switch on the STAGEPAS 100 to turn on the
power to the unit.
The [POWER] LED lights up.
6 While playing your musical instrument or
singing into the microphone, use the
[LEVEL] controls to adjust the volume of
the corresponding channels.
If you can hear sound and the volume seems appropriate,
setup is complete. If not, please refer to the checklist in the
“Troubleshooting” section (page 15).
NOTE
When you turn off the power to all devices, first turn off the power to
the STAGEPAS 100, and then turn off the connected sound sources
(such as a musical instrument or audio device) to avoid any loud,
unexpected noises from the speaker.
Adjusting the volume
• When the volume is too loud
First, turn the [LEVEL] controls to the minimum (zero). Set the
[MIC/LINE] switch to the LINE (O) position, then slowly raise
the [LEVEL] controls until the desired volume is reached.
• When the volume is too low
First, turn the [LEVEL] controls to the minimum (zero). Set the
[MIC/LINE] switch to the MIC (N) position, then slowly raise
the [LEVEL] controls until the desired volume is reached.
Off
Lit steadily
Front panel
Rear panel
Loading ...
Loading ...
Loading ...