Loading ...
Loading ...
Loading ...
en Timer
50
7. To exit the configuration menu, se-
lect one of the following options:
‒ Press and hold
, or .
‒ Start processing.
9 Timer
You can read off the processing time
elapsed or preset a time.
Tip:You can also monitor times with
the timer, e.g. resting times for
dough.
9.1 Display values of timer
Observe the following values when
using the timer.
Display range 0 seconds to 3
hours
Display steps 1second
Settings range 5 seconds to 3
hours
Settings steps 5 seconds
9.2 About the timer
To ensure optimum use of the timer,
note the following.
Notes
¡ If the timer is stopped or switched
off during processing, processing
will continue.
¡ When processing is started with
the timer running, the appliance
will end processing on expiry of
the remaining time.
¡ If you interrupt processing for less
than 3minutes, the last values dis-
played are saved and will resume
if processing starts again.
Tips
¡ You can adjust the remaining time
using
or at any time.
¡ Values will change faster if
or
is pressed and held down.
¡ You can change the volume of the
signal tones at any time.
→"Overview of basic settings",
Page49
9.3 Reading off and resetting
the processing time
Note
Display of the previous processing
time will not start
¡ if the processing time has been
preset.
¡ if the SensorControl Plus function
is used.
1. Set the rotary switch to the re-
quired speed.
a The display shows "TIME" and the
previous processing time.
2. To reset the display to "00:00",
press and hold
.
9.4 Processing ingredients
with the timer
Requirement:The appliance is pre-
pared and the ingredients have been
added.
→"Processing ingredients with tools",
Page48
1. If the display is switched off, press
any button.
2. Press
.
a The display shows "TIMER" and
"00:00".
3. Use or to set the required
duration.
4. Set the rotary switch to the re-
quired speed.
a The display shows the remaining
processing time.
a Once this time has elapsed, a sig-
nal tone sounds and the display
shows "END" "TIMER".
Loading ...
Loading ...
Loading ...