Loading ...
Loading ...
Loading ...
Faults and what to do about them. en
35
Faults and what to do about them.
r has lit up ■ Turn on the cold water tap fully.
■ The supply hose is kinked/jammed. Correct the position of the hose.
■ The water pressure is too low. Clean the filter. ~ Page 33
E The childproof lock is activated – deactivate it.
Å has lit up Too much foam has been detected and additional rinse cycles have been acti-
vated. Add less detergent to the next wash cycle with the same load. ~ Page 28
: the "Ready in" time is
flashing
The mains voltage is too low.
. the "Ready in" time is
flashing
Undervoltage during the wash programme.
The length of the programme will be extended. ~ Page 30
E:18 ■ The drain pump is blocked. Clean the drain pump.
■ The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
~ Page 33
E:23 There is water in the base trough; the appliance is leaking. Turn off the tap. Call
customer services.
H:32 is flashing alter-
nately with End at the
end of the programme
Not a fault – the unbalanced load detection system has interrupted the spin cycle
because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum. Run the spin cycle
again, if necessary.
Other indicators/sym-
bols
Switch off the appliance, wait for five seconds and then switch it on again. If the
indicator/symbol appears again, call our customer services. ~ Page 37
Faults Cause/remedy
Water is leaking from the
machine.
■ Attach the drain hose correctly or replace it.
■ Tighten the threaded joint on the supply hose.
The appliance is not filling
with water.
Detergent is not being dis-
pensed.
■ Have you pressed the Start button?
■ Is the tap turned on?
■ Could the filter be clogged? Clean the filter. ~ Page 33
■ Is the supply hose kinked or trapped?
The door will not open. ■ The safety function is active. Do you want to stop the program?
~ Page 29
■ Is the childproof lock E activated? Deactivate it. ~ Page 28
■ Is - - - selected (Rinse Stop = no final spin)? ~ Page 29
■ Can the door only be opened by the emergency release? ~ Page 34
The program will not
start.
■ Have you pressed the Start button?
■ Is Ready in selected?
■ Is the door closed?
■ Is the childproof lock E activated? Deactivate it. ~ Page 28
Symbol Cause/remedy
Loading ...
Loading ...
Loading ...