Loading ...
Loading ...
Loading ...
Positioning and connecting en
17
Before washing for the first
time
The washing machine has been
thoroughly tested before leaving the
factory. To remove any water that may
be left over from testing, run the first
wash cycle without any laundry.
Notes
■ The washing machine must be
correctly installed and
connected. See ~ Page 11
onwards
■ Never use a damaged machine.
Inform customer services.
1. Check the machine.
2. Connect the mains plug.
3. Turn on the tap.
4. Close the door (do not load any
laundry).
5. Depending on the model, set the
Drum clean 90 °C or Cottons
90 °C programme.
6. Open the detergent drawer.
7. Pour approximately 1 litre of water
into compartment II.
8. Pour standard detergent into
compartment II.
Note: To prevent foaming, only
use half the amount of detergent
recommended by the detergent
manufacturer. Do not use
detergents intended for woollens
or delicates.
9. Close the detergent drawer.
10.Press the Start button.
11.When the programme ends, switch
off the appliance.
Your washing machine is now ready
to use.
Transportation
E.g. when moving house
Preparatory work:
1. Turn off the tap.
2. Reduce the water pressure in the
supply hose: ~ Page 33; Cleaning
and maintenance – filter in the water
supply blocked
3. Disconnect the washing machine
from the mains.
4. Drain the remaining water:
~ Page 32; cleaning and
maintenance – the drain pump is
blocked, emergency draining
5. Remove the hoses.
Attach the transport locks:
1. Use a screwdriver to remove the
covers and then keep them in a safe
place.
2. Insert all four sleeves.
Loading ...
Loading ...
Loading ...