Loading ...
Loading ...
Loading ...
Maintenance
Daily mainte-
nance before
operation
Maintenance
interval
50 hours or
one time each
year
Charge the battery to a minimum of 80 %. Do a check of the battery status in
HSH.
O
Make sure that nuts and screws are tightened to the correct torque. O
Do an inspection, lubricate and adjust all wires. O
Do a check of the steering chain of the inner side of the frame tunnel. O
Lubricate the pedals on the inner side of the frame tunnel. O
Lubricate the operators seat. O
Remove the drive wheels and lubricate the axles with grease. O
Examine and adjust the parking brake. O
Lubricate the cutting deck frame and the cutting deck presence control. O
Lubricate the pivot wheels on the cutting deck. O
Examine the blades. Sharpen and balance the blades if it is necessary. O
Do a check of and adjust the parallelism of the cutting deck. O
Do a check of the switches on the cutting deck, lift and parking brake. O
Do a check of the blade engagement and OPC switch. O
Do a check of the forward drive and rearward drive on different speeds. O
Do a check of the pedal sensor system and adjust if it is necessary. O
To clean the product
CAUTION: Do not use a high-pressure
washer or a steam cleaner. Water can go
into bearings and electrical connections and
cause corrosion which causes damage to
the product.
Clean the product immediately after use.
• Before you clean with a wet cloth, clean with a
brush. Remove grass cuttings and dirt on and
around the propulsion unit and the inlet to the
cooling fan of the motor.
• Use a wet cloth to clean the product.
• Do not use water at electrical components or
bearings. Detergent usually increases the damage.
• Make sure the battery and battery charger are clean,
before the battery is put in the battery charger.
• To clean the cutting deck, remove it and hose it
down with water.
• When the product is clean, start the cutting deck for
a short period to blow off remaining water.
To remove the covers
To remove and install the battery cover
1. Release the 2 clips on the front of the battery cover
with the tool attached to the power switch key.
1263 - 006 - 27.04.2022 21
Loading ...
Loading ...
Loading ...