Loading ...
Loading ...
Loading ...
To start and stop the SavE function
The product has a battery save function (SavE)
that gives longer operation time. The SavE function
decreases the speed of the product and the speed of
the blades.
1. Long press the SavE button.
Note: The SavE indicator comes on with a
constant green light when the function is started.
2. Long press the SavE button again to stop the SavE
function.
To stop the product
1. Park the product on level ground.
2. Apply the parking brake.
3. Pull the lift lever for the cutting deck rearward to lift
the cutting deck to transport position.
4. Set the power switch to "0".
To get a good result
• Do not cut a wet lawn. Wet grass can give a bad
result.
• Start with a high cutting height and decrease it
gradually.
• Cut with blades that rotate at high speed (for highest
permitted motor speed, refer to
Technical data on
page 29
). Move the product forward at low speed.
If the grass is not too high and thick, you can get a
good result also at a higher speed.
• To get the best result, cut the grass frequently and
use the mulch function. Refer to
To remove the
mulch plug on page 22
.
Maintenance
Introduction
WARNING: Read and understand the
safety chapter before you do maintenance
on the product.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
Note: If more than one time interval is identified
in the table, the shortest time interval is for the first
maintenance only.
Maintenance
Daily mainte-
nance before
operation
Maintenance
interval
50 hours or
one time each
year
Make sure all fasteners are properly tensioned (screws, nuts etc). *
Clean as given in
To clean the product on page 21
. X
Clean the inner surface of the cutting deck, around the blades. X
Make sure that the safety devices are not defective. X
Examine and do a test of the brakes. Refer to
To do a check of the forward
pedal and rearward pedal on page 13
and
To do a check of the parking brake on
page 22
.
X
Examine the steering cables. Refer to
To examine the steering cables on page
22
.
X
Examine the blades in the cutting deck. X
Clean the cutting deck and below cutting deck cover. X X
Make sure that the tire pressure is correct. X X
Connect product to HSH and update the firmware if it is necessary. O
20 1263 - 006 - 27.04.2022
Loading ...
Loading ...
Loading ...