Loading ...
Loading ...
Loading ...
iNSTALLiNG THE JOINTER==-PLANER
]f the Jointer-Ptaner is to be used in a permanent location, tt
should be fastened securely to a firm supporting surface such
as a workbench_ Holes should be drilled through supporting
surface of the workbench as illustrated Each foot of the Jotnter-
Planer should be bolted securely using 5/!6" diameter machine
botts, 5f16" hex nuts, and look washers, Bolts should be of
sufficient tength to accommodate foot of Jointer-Raner, washer,
hex nuts, and thickness of supporting surface, Tighten all four
bolts securely_ tf the Jointer-P]aner is to be used in a portable
application, it is recommended that it be fastened-tea mounting
board The board should be of sufficient size to avoid tipping of
Jointer-Ptaner while tn use Any good grade of plywood ot chip-
board with a 3/4" minimum thickness is recommended Mount
Jolnter.Planer to board using hole pattern as shown Clamp
board securely to workbench or supporting surface,.
[
!-I
-#---I_ ,..-_ KNOB
SIDE WITH SWITCH/_ .......
Supporting surface where Jolnter-Planer ts mounted should be
examined carefully after mounting to insure that no movement
during use can result, tf any "tipping" or "walking" is noted,
secure workbench or supporting surface before operating
CONTROLS AND ADJUSTMENTS
,_ CAUTION: MAKE SURE THE SWITCH tS OFF AND THE CORD IS UNPLUGGED BEFORE PER-
FORMING ANY CHECKS OR ADJUSTMENTS,
FENCE TILT
INDICATORS
3 CUTTER GUARD
4 GUARD STOP
ON - OFF
SWITCH
4 DEPTH OF CUT
!
HAND KNOB
1. DEPTH OF CUT HAND KNOB
Turning the hand knob clockwise raises the infeed table and
decreases the depth of cut Turning it counter-clockwise
lowers the infeed table and increases the depth of out to the
maximum 118" depth per pass
NOTE: When the table is lowered for the maximum 1t8"
depth cut, the hand knob will be relieved of lension and
will be loose If this is disturbing, simply turn the hand knob
clockwise until tt is again under tension Turn the knob no
more than 112turn after it is again under tension This will
not change the depth of cut setting unless !I2 turn is
exceeded
NFEED TABLE
H OF
CUT HAND
KNOB
Loading ...
Loading ...
Loading ...