Loading ...
Loading ...
Loading ...
Forbevelingandchamferingoperations, follow the same
procedure as for jointing and planing described on pages 10 and
1t Before performing these operations make sure the surface of
the work piece that contacts the fence is fiat and smooth Main-
tain firm control of the work piece at all times holding it firmly
against fence surface and tabie surfaces,
Use hold downlpush bfocks for wood under 3 in, wide Position
them so you have contro_ of the work piece at ail times and so
they do not contact the guard or the cutter head
USING A WET--DRY VAC
Your Jointer-Ptaner has a rear chip exhaust which fits all
Craftsman Wet-Dry Vacs with a 2-1/2 inch hose A 2-112 In, to
1-114 in, hose adapter is supplied with the machine for 1-1/4 in,
hose connect}ons, Attaching a Craftsman Wet-Dry Vac will keep
your work area cleaner, Craftsman Wet-Dry Vacs are available at
Sears Catalog and Retail Stores.
WARNING: DO NOT REMOVE CHIP DEFLECTOR EVEN
_F VACUUM HOSE REMAINS PERMANENTLY ATTACH-
ED TO MACHINE, NEVER LEAVE HOSE ON MACHtNE
DURING OPERATION iF A VAC IS NOT USED DURING OPERA-
TtON OR THE HOSE AND MACHINE WiLL CLOG WITH CH_PS
CHiP EXHAUST =
VACUUM PORT
MAINTENANCE
TIMING BELT REPLACEMENT
1 UnpJug your Jointer,.Planer and put switch in OFF position
,_ DANGER: FAILURE TO UNPLUG YOUR JO_NTER--
PLANER COULD RESULT IN ACCIDENTAL STARTING
CAUSING SERIOUS iNJURY
2 Remove access covet plate by loosening two pan head screws
under the machine and one located under the cutter guard,
being careful not to damage or disconnect the switch wiring
DO NOT remove cutter guard or guard spring from access
cover,
3 Remove old timing belt by turning belt and maintaining out-
ward pressure
4 Replace with new tfmlng belt by turning belt end maintaining
inward pressure NOTE: Make sure full width of bett is on
both pulleys,,
CUTTER GUARD RETURN SPRING
_[! O NOT LUBRICATE THE PIVOT POINT OF THE CUTTER
GUARD
Oil and lubricating products may contain chemicals that can
damage andtor destroy the cutter guard or other plastic parts
12
CAUTION: fF THE CUTTER GUARD FAILS TO OPERATE
PROPERLY (SEE "CONTROLS AND ADJUSTMENTS '!
SECTION), THE CUTTER GUARD RETURN SPRING WILL
NEED REPLACING CONTACT YOUR NEAREST SEARS STORE
OR SERVICE CENTER FOR REPLACEMENT SPRING AND IN..
STRUCTIONS BEFORE USING THE JOINTER--PLANER
Loading ...
Loading ...
Loading ...