Loading ...
Loading ...
Loading ...
FENCE
1.. From among the loose parts find the following:
(1) Fence
(2) Fence Brackets
(2) Fence Segments
(2) Tilt Indicators
(2) Lock Knobs
(4) 114-20 x 3t4" Hex Cap Screws
(4) 1t4 Lock Washei's
(4) 9132 ID x 91t60D x 11t6 Thick Washers
NOTE:USE OF WASHER_ LEES THAN 1/_ THICK LOCK KNO_
MAY RE/;DLT |t_ FENCE Tt(]HTEN_ND PROBLEM_; _132 _DX _Tt3_OD
(2) 9f32 ID x 17132 OD x 1/8 Thick Washers ._ j_L._,jA.2_
(6) #8-32 x !12 Flat Head Machine Screws
FE
',o (6) #8 Fiat Washers EASE. HCESnAC_ ,,A_2_AX_H_Xw
(2) #10-24 X 112 Pan Head Machine Screws \,._
(2)#10 FEat Washers 1 ___'_1%_"; °°c"wAsH" __ ......
9132 ID x 1/16 thick washers and 114lock washers, snug but do not
tighten #t0.z4x_/2PAN,_0
2. Attach fence segments to fence with #8-32 flat head screws, #8 flat _"_ I _CH=NESCREW
washers and #8-32 hex nuts.
3 PIEce assembled fence on machine with fence brackets inside the
fence segments
4 Position lock knobs with 9/32 tD x t7/32 OD x 118 thick washers thru
slots in fence segments and thread into fence brackets
5 Place squa_'e against face of fence and table surface Bring fence
square to table and tighten lock knobs.
6 THERE MUST BE 1/32" TO 1t16" gap between the lower edge of the
fence and jointer tables (with table set for 0" cut). To adjust, move
fence assembly by loosening the 1t4-20 x 314hex cap screws attach-
ing the fence brackets to the base Retighten hex cap screws after
adjustment has been made
7
8
9,,
Recheck squareness of fence,, _ / TILT INDICATOR SHOULD DE LINED UP WITH
r_ t_ll LU_=_,.--"_,_.}_'_,_ THE FENCE SEGMENT AT THE O'MARK
Install tilt indicators with #t0-24 x 112 pan head machine screw and _- _._ _*'J_l,_ DO NOT OVER
#10 flat washers_ Set 0 ° of indicators to 0 ° of segments and tighten "_-_.. _-_.._ TIGHTEN
thescrew
The fence should now be adjusted and wilt accurately measure angles 2r" .'="_/" -" _'___ '"-
FENCE EXTENSION
To aid in edge jointtng of workpteces 4" and wider, you may extend the
fence height. The extension can be constructed of 1" (314" thick) stock
pine or hardwood..
Use #8 flat head wood screws of sufficient length to securely attach the
extension to the fence Make sure that the head of the screws are below
the surface of the fence so as not to interfere with the workpiece
For extra stability, additional countersunk holes may be drilled in the
fence for flat head screws.
w
C
1/4
#,8 FLATHEAD - '
COUNT_ SCREW_
FENCE-t
Loading ...
Loading ...
Loading ...