Loading ...
Loading ...
Loading ...
2. Sanitizing Procedure - Following Cleaning Procedure
1) Dilute approximately 0.31 . oz. (9.2 ml) of an 8.25% sodium hypochlorite solution
(chlorine bleach) with 1 gallon (3.8 lit.) of warm water. Using a chlorine test strip or
other method, conrm that you have a concentration of about 200 ppm.
2) Soak the removed parts from step 19 above in a clean container containing the
sanitizing solution. After allowing the parts to soak for 10 minutes, wash them with the
solution. Also wash the bin liner and brackets (L) and (R) with the solution.
3) Discard the sanitizing solution and rinse the parts thoroughly with water.
4) Replace the removed parts in their correct positions in the reverse order of which they
were removed.
5) Dilute approximately 0.31 . oz. (9.2 ml) of an 8.25% sodium hypochlorite solution
(chlorine bleach) with 1 gallon (3.8 lit.) of warm water. Using a chlorine test strip or
other method, conrm that you have a concentration of about 200 ppm.
6) Pour the sanitizing solution into the water tank, and allow the sanitizer to sit for 10
minutes.
7) Move the service switch to the “WASH" position, then move the control switch to the
“SERVICE" position.
8) After 15 minutes, move the control switch to the “OFF" position.
9) Move the service switch to the “DRAIN" position, then move the control switch to the
“SERVICE" position.
10) After 2 minutes, move the control switch to the “OFF" position.
11) Repeat steps 5 through 10 one time. Repeat steps 9 through 13 in the Cleaning
Procedure three times to rinse thoroughly.
12) After 2 minutes, move the control switch to the “OFF" position.
13) Flush the ice storage bin with water.
14) Move the control switch to the “ICE" position to start the automatic icemaking process.
15) Close the door. Replace the louver in its correct position.
25
Loading ...
Loading ...
Loading ...