Loading ...
Loading ...
Loading ...
6) Release the fluid into the pump after test is completed.
Note:
1. Only up-inlet injector can fit Reverse Flushing.
2. Need not set up pulse width, system use default value.
3. Please make sure the test fluid is clean, so that the injector will not be
blocked.
3.4 Non-dismantle Cleaning(optional function)
To clean the whole fuel system of the engine, including fuel supply
system, burning room and the injector. .
3.4.1 Preparation
1) Move the screw on the bottom of test fluid bottle, and release all test
fluid.
2) Open the cover of the engine chamber. Find out the fuel supply hose
and return hose of the fuel system.
3.4.2 Steps
12 Non-dismantle Cleaning
1) Take the red long hose from the accessories box. Connect one end to
return hose of the engine, and the other end to the return hose port of
the machine.
2) Run the engine, and check the test fluid bottle. When the level is up
to 600-800ML, stop the engine.
3) Take the long blue hose from the accessory box. Connect one end to
the high pressure port of the machine, and the other end to the supply
hose of the engine fuel system.
4) Move the pump relay of the engine or short connect the fuel circuit of
the engine fuel pump. (In this case, please make sure the cover of fuel
tank is open.)
5) Turn on the machine. Press Left or Right Arrow key to select
Non-dismantle Cleaning, and set up the time as 20-30minutes.
Loading ...
Loading ...
Loading ...