Loading ...
Loading ...
Loading ...
troubBe shooting
WARNING: FOR YOUR OWN SAFETY, TURN
SWITCH "OFF" AND REMOVE PLUG FROM
POWER SOURCE OUTLET BEFORE TROUBLE
SHOOTING YOUR SANDER.
TROUBLE
Motor will not run.
Machine slows down
when finishing.
TROUBLE SHOOTING CHART
PROBABLE CAUSE
1 Defective On-Off switch
Defective switch cord
Defective switch box receptacle_
2. Motor protector open, (only if
your motor is equipped with an
over load protector).
Other cause,.
V-Belt too loose,
2.
3
1,
2,
Applying too much pressure to
workpiece
Too much tension on abrasive
belt_
2
REMEDY
1
2
3.
t
1
2.
1,
Replace defective parts before using belt disc
sander again,.
Consult Sears Service. Any attempt to repair this
motor may create a HAZARD unless repair is
done by a qualified service technician Repair
service is available at your nearest Sears Store
Increase belt tension, seeAssembly Section,
"Motor Pulley Belt Guard and Motor
Installation."
Ease up on pressure
Adjust tension, see Assembly Section, "Installing
and Adjusting Abrasive Belt."
Abrasive Belt Slips Not enough tension Adjust tension, seeAssembly Section, "Installing
and Adjusting Abrasive Belt."
Abrasive Belt tuns Not tracking properly Adjust tracking, seeAssembly Section, "Installing
off pulleys, and Adjusting Abrasive Belt."
Not enough tension. Adjust tension, seeAssembly Section, "Installing
and Adjusting Abrasive Belt."
Wood burns while Abrasive disc or belt is glazed with Replace disc or belt.
finishing, sap_
................... RECOMMENDED ACCESSORIES _ _ ,
IN CANADA, SEE YOUR LOCAL SIMPSONS-SEARS STORE OR CATALOG FOR ACCESSORY
SELECTION AND NUMBERS
ITEM CAT. NO,
Floor Stand .................................. 9-22213
Miter Gauge .................................... 9_29929
Stick Disc Cement .......................... 9-2219
Abrasive Belts and Disc ................... SEE CATALOG
Steel Legs ....................................... 9-22236
Stop Rods ........................................ 9-29924
Power Tool Know How Handbooks .........................
Radial Saw ..................................... 9-2917
Table Saw .................................... 9-2918
The above recommended accessories are current and were available at the time this manual was printed,,
24
Loading ...
Loading ...
Loading ...