Loading ...
Loading ...
Loading ...
BELT ADJUSTING
SCREW
(ONE ON EACH SIDE)
1,BELT ADJUSTING SCREWS causethe idler pulley to
move in or out for applying tension to the belt or for
tracking it They are adjusted using the 1/2" wrenches
See "Assembly" section .... "Installing Abrasive
Belt"
2, BELT LOCKING SCREWS lock the adjust ment mech-
anism after the abrasive belt is tensioned and tracking
properly They are locked using the 1/2" wrench_
See "Assembly" section ...... "Installing Abrasive
Belt"
\
BELT LOCKING
SCREW
3 WORK TABLE TILT LOCI( SCREW locks
the table, It is locked using the 1/2" wrench
a Using a combination square, check the angle of
the table with the disc
NOTE: The combination square must be "true"-
Sea start of assembly section on Pg. 6 for checking
method
b If time table is not 90 ° with the disc loosen
tilt lock screw and tilt table
c Loosen the lock nut using a 7/16" wrench
d Screw time stop screw in or out, using a 7/16"
wrench so that when the table touches the stop
screw, the table is 90 ° to time disc
e Tighten the lock nut
TABLE POSt'f IONtNG
LOCK SCREW
. I j'--
I L )?)1 SCREW
- -iz 2--J T,LT
LOCI( NUT t
LOCi(
SCREW
19
Loading ...
Loading ...
Loading ...