Loading ...
Loading ...
Loading ...
assembly
INSTALLING ABRASIVE BELT-TENSIONING
AND TRACKING
WARNING: FOR YOUR OWN SAFETY, TURN
SWITCH "OFF" AND REMOVE PLUG FROM
POWER SOURCE OUTLET BEFORE REMOV-
ING OR INSTALLING ABRASIVE BELT°
On the smooth side of tile belt you will find a "direction-
al arrow"The belt must run in the direction of this arrow
so that the splice does not come apart
1 Loosen the two belt LOCKING screws
2 Place the belt over the pulleys with the directional ar-
row pointing as shown Make sure the belt is centered
on both pulleys
Turning the belt ADJUSTING screws will cause the idler
pu!ley to move in or out When the idler pulley is moved
outward, it puts TENSION on the belt
3 Place both of the 1/2" wrenches on the ADJUSTING
screws and pull the wrenches toward you This will
stretch the belt Move the wrenches back and fortha
few times so that you "get the feel of the belt while
it is stretching (TENSIONING)
Apply a small amount of TENSION to the belt by
pulling the wrenches toward you, so that the TEN-
StON feels the same on both wrenches
PULL WRENCHES IN THIS
DIRECTION TO APPLY
TENSION
DIRECTIONAL ARROW_
BELT ADJUSTING SCREWS
BELT LOCKING SCREW
4_ Hold the disc with your left hand to keep it from
turning while pushing the belt in the direction of the
arrow If the belt slips over the pulleys, turn both AD-
JUSTING screws simultaneously asmall amount to ap-
ply a little more tension to the belt
5 Adjust the tension so that the belt does not slip very
easily when pushing it, while you are holding the disc
6 Tighten the locking screws
7 Plug in the power cord Turn the switch "on", let the
machine run for about three to five seconds and then
turn it "off" Notice if the belt while running, moved
to the right or to the left.
If it did not move to the right or left, it is
TRACKING properly
BELT LOCKING SCREW
PUSH BELT IN DIRECTION
OF ARROW
16
Loading ...
Loading ...
Loading ...