Loading ...
Loading ...
Loading ...
LIGHTING
7
LIGHTING INSTRUCTIONS
1. The appliance must be assembled as per the assembly
instructions.
2. Ensure LP cylinder is full and properly connected to the
regulator. See: “Hose and Regulator.” (page 5)
3. Ensure there are no gas leaks in the gas supply system. See:
“Leak Testing.” (page 6)
4. Ensure that the venturi tubes are properly located over the gas
valve orifice. (see Venturi diagram, page 6)
5. Ensure that the Main Burner ignition wire is connected.
6. Carefully review all instructions on the information plate attached
to the smoker.
7. WARNING: Always open the door before lighting and do not lean
over the smoker while lighting.
8. Set control knobs to “OFF” and turn on the gas supply.
LIGHTING THE BURNER
a. Open the smoker door and leave open until lit.
b. Check that the battery has been installed in the electronic
ignition.
c. Push and turn one the main control knob to “HIGH.”
d. Push and hold down the ignitor button or use match to light.
e. Burner should ignite within 5 seconds; turn off gas source
immediately if ignition does not occur in this timeframe. To light
burner with a match proceed below to step f
f. Attach match to the match light chain and light.
g. Lower lit match to the burner.
h. Push and turn right main burner control knob to “HIGH.”
i. Burner should ignite within 5 seconds.
CAUTION - Check your gas grill after lighting. All burner
ports should show a 1in / 2.5cm flame on “HIGH.”
If any of the following symptoms occur there is probably a blockage
in the venturi tubes. Shut off gas at once and clean the venturi
tubes. See “Venturi Tubes.” (page 6)
1. You smell gas.
2. A flashback fire occurs.
3. Your Smoker heats unevenly.
4. The burner make popping noises.
IF BURNER DOES NOT IGNITE
OR BURNER EXTINGUISHES:
1. Push and turn control knob to “OFF.” Wait 5 minutes then try
again with control knob set at “MEDIUM.”
2. If the burner will not light, see “Troubleshooting” on page 11. If
problems persist, do not attempt to operate the appliance;
contact OMC, your dealer or an approved service center.
SHUTDOWN:
1. Turn off cylinder valve.
2. Turn control knobs to “OFF.”
Match lighting the burner using the match light chain.
Loading ...
Loading ...
Loading ...