Loading ...
Loading ...
Loading ...
5
A
AB
C
CB
1
2
3
4
D
D
Mounting (Rack)
Mount your equipment in either a 2-post or 4-post rack or rack enclosure. The user must
determine the fitness of hardware and procedures before mounting. If hardware and procedures
are not suitable for your application, contact the manufacturer of your rack or rack enclosure.
The procedures described in this manual are for common rack and rack enclosure types and
may not be appropriate for all applications.
Note: The illustrations may differ from your model.
4-Post Mounting
1
The included plastic pegs
A
will
temporarily support the empty rack-mount
shelves
B
while you install the permanent
mounting hardware. Insert a peg near the
center of the front and rear bracket of
each shelf as shown. (Each front bracket
has 6 holes and each rear bracket has 3
holes.) The pegs will snap into place.
After installing the pegs, expand each
shelf to match the depth of your rack rails.
The pegs will fit through the square holes
in the rack rails to support the shelves.
Refer to the rack unit labels to confirm
that the shelves are level in all directions.
Note: The support ledge of each shelf must
face inward.
2
Secure the shelves
B
to the mounting
rails permanently using the included
screws and cup washers
C
as shown.
Place the cup washer between the screw
and the rack so that the screw enters the
wider opening of the cup washer first.
Place 4 screws total at the front and 4
screws total at the back.
Tighten all screws before proceeding.
WARNING: Do not attempt to install your equipment until you have inserted and
tightened the required screws. The plastic pegs will not support the weight of your
equipment.
3
Attach your equipment’s mounting
brackets to the forward mounting holes of
the cabinet using the hardware included
with your equipment. The mounting
bracket “ears” should face forward. (Some
equipment may have pre-installed or
integral mounting brackets.)
4
With the aid of an assistant (if necessary),
lift your equipment and slide it into the
shelves. Attach the equipment mounting
brackets to the forward mounting rails with
user-supplied screws and washers
D
.
Tighten all screws securely.
Loading ...
Loading ...
Loading ...