Loading ...
Loading ...
Loading ...
Adjustments (continued)
Blade Elevation
When the eIevation handwheel is turned clockwise, until
it stops, the blade must not be more that 2-5/8 inches
above the table If the b}ade extends more than 2-5/8
inches, the motor could interfere with the underside of the
table causing misalignment,
With the blade extending 2-5/8 inches above the table,
the stop collar and spacer must be against the elevation
screw pivot nut If the blade extends more that 2-5/8
inches, loosen two screws in stop collar, and readjust it,
Step
Elevation
Spacer
!
I
"Elevation Screw
Pivot Nut
1
f
Tilt Screw
Tilt Screw
Pivot Nut
Tilt and Elevation Mechanism
The handwheels should turn freely without binding, The
turning action can be adjusted by tighten{ng or loosening
the screws in the bearing retainer Both handwheels
must be removed to reach the adjusting screws
NOTE: When adjusting the screws on the tilt bearing
retainer, ho_d the nut inside using a 3/8" wrench, The
screws for the elevation bearing retainer can be reached
with a small screwdriver through the curved slot on the
front of the saw
Tilt
Handwheel
Elevation
_'_ _-_ Handwheel
Adjust Thes_ ! ,_'_-,,_J_
Two Screws _ _OJ F[_
Adjust These
Two Screws
42
Loading ...
Loading ...
Loading ...