Loading ...
Loading ...
Loading ...
Basic Saw Operations (continued) ...................
Ploughing and Molding
Ploughing fs grooving with the grain the tong way of the
workpiece, using the fence Use featherboards and push
sticks as required
Molding is shaping the workpiece with the grain the long
way of the workpiece, using the fence. Use feather-
boards and push sticks as required
Ploughing
Molding Cutting
Instructions for operating the molding head are contained
in a booklet furnished with the molding head..
Always use the molding insert listed under recom-
mended accessories.
When using the molding head it will be necessary to
remove the blade guard and spreader Use caution Use
miter gauge, fence, featherboards, or push sticks, etc.,
as required
I WARNING: For your own safety, always replace the I
blade guard and spreader when you finished plough-
Iing or molding.
Molding
Adjustments
WARNING: For your own safety, turn switch "OFF"
and remove plug from power source outlet before
making any adjustments,
Miter Gauge
NOTE: The graduations are manutactured to very close
tolerances which provide ample accuracy for fine wood-
working In some cases where extreme accuracy is
required, when making angle cuts, for example, make a
trial cut and then recheck it
The head should be square (90°) with the bar when the
pointer points to "0"
To check for squareness, place an accurate square on
the miter gauge itthe head is not square with the bar:
1 Loosen the lock knob
2. Position the head square with the bar Tighten the lock
knob
3 Loosen the screw and adjust the pointer, so it points to
zero
The swiveling movement of the head can be adjusted by
tightening or loosening the set screw located inside of the
head using a 1/8" hex "L" wrench
1
Miter Gauc Knob Pointer
Head
Bar
36
Loading ...
Loading ...
Loading ...