Loading ...
Loading ...
Loading ...
7
ENG
WARNING!
Gas hose and electric connection of the appliance should not pass next to hot areas such as back of the appliance.
Gas hose should be connected by making wide angle turns against breaking possibility. Movement of appliance
whose gas connection is made may cause gas leakage.
Correct Correct CorrectIncorrect
For natural gas connection
Transformation from natural gas to LPG and from LPG to natural gas
WARNING!
Natural gas connection should be done by authorized service.
For natural gas connection, place gasket in the nut at the edge of natural
gas connection hose. To install the hose on main gas pipe, turn the nut.
Complete the connection by making gas leakage control.
1. Turn off gas and electricity of the cooktop. If your cooktop is hot, wait for cooling down.
2. For injector change, use a screwdriver whose edge is as the figure 1.
3. As seen in figure 2, demount burner lid and burner of the cooktop and ensure visibility of injector.
4. Remove injector by turning as shown in figure 3 with screwdriver and replace it with a new one.
5. After that, detach control switches of the cooktop. Make setting by turning the screw in the middle of gas cocks
with a small screwdriver in the manner shown in the following picture. To adjust flow rate screw, use a screwdriver
having suitable dimension. For LPG, turn the screw clockwise. For natural gas, turn the screw one time counter
clockwise. At low position, length of normal flame should be 6-7 mm. For the last control, check out whether
flame is open or closed.
Setting of your appliance may differ according to the type of gas cock used.
Main gas pipe
Gasket
Nut
Natural gas
Connection hose
Figure 1 Figure 2 Figure 3
Loading ...
Loading ...
Loading ...