Loading ...
Loading ...
Loading ...
22
3.9 Installing the Holster
NOTE
The procedures below are only applicable to the separate holster model.
Place the holster on a location where no tension is applied to the charging cable.
1. Place the wall dock on the wall and level it
using a spirit level.
2. Mark the three mounting holes (A) with a
pencil and drill three 5/16" holes.
3. Insert three 5/16" diameter wall anchors
(B) into the holes.
4. Attach the wall dock to the mounting
location by inserting three M6 x 50 screws
(C) into the holes. Tighten the screws using
the PH2 screwdriver (not included in the
package).
5. Position the holster to fit the grooves (D) of
the wall dock. Ensure the installation is
secure.
6. Insert the M5 x 12 screw (E) into the hole
at the bottom of the holster and tighten it
using the T25 Torx screwdriver.
7. Drape the charging cable over the top of
the charger or holster and dock your EV
connector in it.
Loading ...
Loading ...
Loading ...