Loading ...
Loading ...
Loading ...
18
Bottom Entry
Insert the AC input cable into the inlet hole (I).
Step 2
1. Strip the wires to 1/2" (12 mm).
2. Connect the wires (L1, L2, and Ground)
as per the diagram and tighten each
connector screw to 17.7 in·lbs (2 N·m).
3. Reinstall the covers and tighten the
screws.
If the connection to the Ethernet cable and/or RS485 cables (see the instructions below) are not needed,
refer to Step 4 and Step 5 in NEMA Plug-in Installation to finish mounting the charger.
Loading ...
Loading ...
Loading ...