Loading ...
Loading ...
Loading ...
14
3.4.2 Hardwired Installation
The MaxiCharger AC Residential 10 kW/12 kW supports both rear entry and bottom entry wiring. Choose the
most appropriate wiring entry for your charger based on the placement of the wiring.
IMPORTANT
Both the rear entry and bottom entry locations are on the left side of the charger. Ensure that you mount
your charger in a location where the power supply wiring can be easily accessed on the left side.
The rear entry cables should be put through the cable inlet holes prior to mounting the charger to the
wall dock.
Placement
1. Find the wall stud nearest to and on the right
side of the power supply wiring using a wall
stud finder.
2. Draw a vertical line of approximately 20" (50
cm) in line with the wall stud at the
approximate height of your mounting.
3. Place the wall dock with the center holes
aligned with the vertical line. Mark the two
lower mounting holes (A) and remove the wall
dock.
4. For rear entry wiring, mark the cable exit
where the AC input cable will come out from
the wall. Ensure that the cable exit matches
the wall dock notch as per the diagram below.
Loading ...
Loading ...
Loading ...