Loading ...
Loading ...
Loading ...
17
- Pull out the filter gently.
- The removal of the filter at the back panel has higher priority than that of the filter at the side panel to avoid any twist or
damage to filter to avoid any twist or damage to filter.
- Do not squash or hit the mesh with sharp objects or brushes.
- Do not use the appliance without installing the filter.
INTERNAL WATER TANK
When the internal water is full of condensed water, the Water-Full indicator will light up.
To Empty the Internal Water Tank:
1. Unplug or disconnect the power.
2. Place a shallow pan (not included) with its volume of 1 quart or more below the lower drain located on the back (near
the bottom) of the air conditioner.
3. Remove the cap and the rubber plug, and then drain the water tank.
4. Re-insert the rubber plug and screw the cap tightly in place.
5. Plug in or reconnect the power.
STORAGE
Please store the air conditioner properly if not in use.
1. Unscrew the drain cover and pull out the stopper to drain the condensed water completely. Or, tilt the unit to drain
water.
2. Keep the unit running in fan mode for a half day to dry the inside completely to prevent it from going moldy.
3. Turn off the unit, pull out the plug, wrap the power cord around the wire-winding pillar, insert the plug into the universal
fixing hole at the back panel of the unit, and install the water stopper and the drain cover.
4. Remove the heat exhaust hose for assembly. Clean and keep it properly.
5. Take out the batteries from the remote controller and place it in the remote control box.
Note:
Ensure the unit is stored in a dry place. All accessories of the unit shall be protected together properly. Keep the unit away
from children.
Loading ...
Loading ...
Loading ...