Loading ...
Loading ...
Loading ...
16
Note:
Protect the drain cover and the water stopper properly.
It is necessary to move the unit carefully to avoid leakage.
Tilt the unit slightly backwards when draining.
Block the drain hole as soon as possible before the tray is full, if it cannot hold all water in the unit, to prevent the
water leakage and prevent the floor or carpet from getting wet.
Water stopper and drain cover must be tightly installed to avoid the new condensate wetting the floor or carpet when
the unit starts working again.
CONTINUOUS DRAINAGE
1. Unscrew the drain cover & unplug the water stopper.
2. Connect drain-hole with φ0.5 inch drain hose as deep as possible to
avoid leakage.
NOTE: If you need the plastic drainage pipe, please purchase one with
its internal diameter 0.5 inch and its length according to the need.
3. Pull the drain hose to bathroom or outdoor.
Note:
Drain hose must be installed when there’s no water in the tray.
It is suggested not to operate continuous drainage when the unit is in COOL mode to ensure enough water recycle in
the unit to enhance the cooling effects.
It is suggested to adopt continuous drainage when the unit is in HEAT mode to avoid frequent drainage.
Put the drain hose in an inaccessible place, not higher than the drainage hole and keep the drain hose straight without
any bends.
Keep the drain cover and its stopper properly when continuous drainage is adopted.
CARE AND MAINTENANCE
WARNING
Be sure to turn off the unit and pull out the plug before maintaining or sending to service center.
SURFACE CLEANING
- Unplug the appliance before cleaning.
- Clean the unit surface with wet soft cloth and do not use chemical solvents, such as alcohol and gasoline, to avoid any
damage to unit. Any thinner, alcoholic extracts (which may affect the glossiness of the surface) or other similar solvents is
prohibited for the cleaning of the unit.
- Clean the dirty air outlet or louvers with wet soft cloth and detergent. Any chemical solvent is prohibited to be used for
the cleaning of the unit or to be put near the unit for a long time.
FILTER CLEANING
- Clean the filter once every two weeks, or it would influence the unit’s function if the filter is clogged with dust.
- Grip the filter handle and pull it out gently in the correct direction. Clean the dirty particles in the filter by cleaner if it is
necessary. Immerse the filter into and wash it gently with warm water (about 104
℉
) mixed with neutral cleaner, and then
rinse and dry them thoroughly in the shade.
Note:
Loading ...
Loading ...
Loading ...