Loading ...
Loading ...
Loading ...
Installation Instructions
[] LIGHT THE PILOTS (cont.}
[] Adjust the Surface Burner Pilots if Necesserg
CAUTION - Mokesurethesurfaceburner
controlknobs are inthe OFF positionbefore
attempting to odjust the pilots.
1. Raise the cooktop.
2.
.
Locate the pilot adjustment screw. It con
be occessed through the small hole near
the center of the manifold panel.
To adjust, use a blade-tgpe screwdriver
with a shaft diameter of less than or equal
to 3/!6". Turn pilot adjustment screw until
pilot flame is 5/!6" high. Do not reduce the
flame to less thon 5/!6" or pilot outage
mog occur A pilot flame burning higher than
recommended maw generate soot (carbon
block) on the bottom of your cooktop.
[] Light the Oven Pilot
1. Ensure the top burners are lit before
ottempting to light the oven pilot (turn them
off offer you have lit the oven pilot).
2. Remove the oven door. See Lift-Off Oven
Door in the Core and cleoning of range
section.
3. Remove the oven shelves.
[] Light the Oven Pilot (cont.)
4. Remove the oven bottom. To remove:
• Remove knurled screws holding down
reor of oven bottom.
• Grosp oven bottom ot finger slots on
eoch side.
• Lift rear of oven bottom enough to clear
the lip of range frame, then pull out.
5. Locote the pilot in the back of the oven
bottom. The pilot is ottached to the left side
of the oven burner.
r_
Shield
(on some
models)
Pilot
6. To light the oven pilot, push in and hold the
oven control knob while lighting the pilot
with a long match or match holder. Once
the oven pilot is lit, continue holding the
oven control knob for one minute before
releasing.
No adjustments are required for natural
gas. If the range is connected to LP gas,
contact the person who installed your
range or made the conversion. If pilot
flame does not stay lit, repeat this step.
38
Loading ...
Loading ...
Loading ...