Loading ...
Loading ...
Loading ...
REMOVING AND INSTALLING CUTTING
ATTACHMENT SHIELD
Remove the cutting attachment shield when using
the unit as a brushcutter.
WARNING: The cutting attachment shield
should NOT be installed when operating the
unit with a blade. Remove the cutting
attachment shield before removing or
installing the blade,
Remove the cutting attachment shield from the shield
mount by removing the three (3) screws with e fiat blade
screwdriver (Fig. 7). Store parts for future use.
Cutting
Attachment
Shield
X
Gear Housing
Shield Mount
Fig. 7
Install the cutting attachment shield when using the
unit as e grass trimmer.
the cutting attachment shield SHALL be in
place at all times whilst operating the unit as
a grass trimmer.
Install the cutting attachment shield on the shield mount
by inserting the three (3) screws into the shield mount.
Tighten securely with a flat blade screwdriver (Fig. 7),
REMOVE THE CUTTING ATTACHMENT AND
INSTALL THE CUTTING BLADE
NOTE: To make removing or installing the cutting blade
or cutting attachment eas_er, place the unit on
the ground or on a work bench
Remove the Cutting Attachment Shield
See Removing ana Installing Cutting Attachment Shield,.
Remove the Cutting Attachment
WARNING: The gear housing gets hot with
use and can result in injury to the operator.
When the unit is turned off it remains hot for
a short time. Do not touch the gear housing
until it has cooled.
Align the shaft bushing hole with the locking rod slot
and insert the locking rod into the shaft bushing hole
(Fig. 8).
Shaft 5ushing Hole
LoP.king Rod
Output Shaft
Fig, 8
2. Hold the locking rod in place by grasping it next to
the boom of the unit (Fig. 9).
3. Whilst holding the locking rod, remove the cutting
attachment by turning it clockwise off of the output
shaft (Fig. 10). Store the cutting attachment for future
use.
NOTE: The blade retainer under the cutting attachment
will be used when installing the cutting blade.
Fig. 9
Cutting Attachment
Locking
Rod Slot
Loc_ng Rod
Fig. 10 .......
Loading ...
Loading ...
Loading ...