Loading ...
Loading ...
Loading ...
STARTING INSTRUCTIONS-COLD WEATHER
These instructions will belo in starting your unit for cold
weather operation, temperatures below 4°C (40°F).
Cold Start - First Start of the Day or Engine Ran Out
of Fuel
WARNING: Operate this unit only in a well
ventilated area outdoors. Carbon monoxide
exhaust fumes can be lethal in a confined
area.
_lb ARNING: Avoid accidental starting. Be in
the starting position whenever pul ing the
starting rope. To avoid serious personal
injury, the operator and unit must be in a
stable position whilst starting
1 Check oil level in crankcase. See Checking the Oil
Level Pg. 21.
2. Fill the fuel tank with fresh, clean, unleaded oetrot
(gasoline) (see page 13),
3, Put the gnition switch in the START position [I]
(Fig. 21).
4. Place the choke lever in the FULL choke (A) H
position (Fig, 22).
5,
Fully press and release the primer bulb slowly 5 to 7
times. Petrol (gasoline) should be felt and visible in
the bulb (Fig. 22). If gasoline has not entered the
bulb, press three more times, or until it does.
6. Whilst pressing the throttle lock-out, squeeze the
throttle control to the wide open (full throttle)
position (Fig. 21).
7. With the unit in the starting position (Fig, 23) pull the
starter rope briskly 5 times in the FULL choke (A) H
position. If the engine attempts to run before the
fifth pull, proceed to step 8.
8. Move the choke lever to the PARTIAL (B) I',_1position
(Fig. 22).
NOTE: The engine will not run in the FULL choke (A) H
position.
9. Pull the starter rope 1 to 3 pulls until the engine
starts (Fig. 23), Run for a minimum of 30 seconds.
NOTE: If the unit failed to start in step 9 move the
choke lever to the RUN (C) _1position (Fig. 22)
and pull the starter rope until the unit starts
(1 to 7 pulls maximum). If the unit still fails to
start, repeat steps 3 through 9.
10. Move the choke lever to the RUN (C) I{I position and
run at full throttle for 30 seconds to one (1) minute.
11. Release the throttle control and allow the unit to idle.
12. Your unit is now ready to operate.
Failed to Start
If your unit failed to start using the above procedure or
dies, repeat steps 1 through 11. If the unit still fails to
start, see the troubleshooting section.
Engine Re-Start - Warm Engine With Fuel
1. Put the ignition switch in the START position [I]
(Fig. 21),
2. Move the choke lever to the PARTIAL (B) Ixl position
(Fig. 22).
3. Whilst pressing the throttle lock-out squeeze the
throttle control to the wide open (fu I throttle)
position (Fig. 21).
4. With the unit in the starting position, pull the
starter rope briskly (Fig. 23) until the engine starts
(1 to 5 pulls).
5,
When the engine starts, run at full throttle for 10 to
30 seconds. Move the choke lever to the RUN (C) ]t l
position (Fig, 22). Release the throttle control and
allow the unit to idle,
NOTE: If the engine does not start using the Engine
Re-start procedures, revert to the Cold Start
procedures.
STOPPING INSTRUCTIONS
1. Release your hand from the throttle control and allow
the unit to idle (Fig. 21).
2. To stop ;he engine, put the Ignition Switch in the
STOP [O] position (Fig. 21).
15
Loading ...
Loading ...
Loading ...