Loading ...
Loading ...
Loading ...
DECORATIVE TRIMMING
Decorative trimming isaccomplished by removing al!
vegetation around trees; posts, fences, etc.
Rotate the whole unit so that the Cutting attachment is at
a 30 ° angle to the ground (Fig. 29).
Fig. 29
USING THE CUTTING BLADE
I_ WARNING: Always wear eye, hearing, foot, I
body protection and the strap to reduce the
risk of injury when operating this unit.
,_ WARNING: Do not use the cutting blade for
edging or as an edger, severe personal injury
to yourself or others can occur. 1
Before operating the unit with the cutting blade stand in
the operating position (Figs. 30). Refer to Holding the
Trimmer, Pg. 17.
Cutting Blade Operating Tips:
To establish a rhythmic cutting procedure:
• Plant feet firmly, comfortably apart.
• Bring the engine to full throttle before entering the
matedal to be cut. The blade has maximum cutting
power at full throttle and is less likely to bind, stall, or
cause kick back, which can result in serious personal
injury to the operator or others.
i_k, ARNING: Kick back may occur when the
spinning blade contacts an object that it
does not immediately cut. Kick back can be
violent enough to cause the unit and/or
operator to be propelled in any direction, and
possibly lose control of the unit. Kick back
can occur without warning if the blade snags,
stalls or binds. This is more likely to occur in
areas where it is difficult to see the material
being cut.
Cut whilst swinging the upper part of your body from
right to left.
• Always release the throttle trigger and allow the engine
to return to idle speed when not cutting.
• When done always unsnap unit from harness before
taking harness off.
18
I_hl WARNING: The blade continues to spin after]
the engine is turned off, The coasting blade I
can seriously cut you if accidentally touched. J
• Swing the unit in the same direction as the blade
spins, which increases the cutting action.
* Move forward to the next area to be cut after the
return swing and plant feet again.
• The cutting blade is designed with a second cutting
edge, which can be used by removing the blade,
turning it upside down, and reinstalling it.
WARNING: Do not sharpen the cuffing
blade. Sharpening the blade can cause the
blade tip to break off whilst in use. This can
result in severe personal injury to yourself or
others. Replace the blade.
To reduce the chance of material wrapping around the
blade, follow these steps:
Cut at full throttle.
g Swing the unit into material to be cut from your right to
your left (Fig. 31).
• Avoid the material just cut as you make the return
swing.
WARNING: Do not clear away cut material I
with the engine running or blade turning. To
I
avoid serious personal injury, turn off engine,
Allow the blade to stop before removing
materials wrapped around the blade shaft.
Fig, 30
Loading ...
Loading ...
Loading ...