Loading ...
Loading ...
Loading ...
INSTALLING AND ADJUSTING THE J-HANDLE
1. Place the J-handle between the top and middle
clamp pieces (Fig. 1)•
J-Handle
Top Clamp
Middle Claml:
Bottom Clamp -"_'
Nuts _°,
................................... Fig. 1
2. Whilst holding the three pieces together, install the
four (4) screws through the top clamp and into
middle clamp.
NOTE: The holes in the top and middle clamp will line up
only when assembled correctly.
3. Place the clamps and J-handle the over the shaft
housing and onto the bottom clamp,
4. Hold each hex nut in the bottom clamp recess with a
finger. Start screws with a large Phillips screwdriver.
Do not tighten until you make the handle adjustment.
5. Slide the J-handle in or out until the arrow/white line
on the decal touches the clamp assembly (Fig. 2):
Fig. 2
6. Whilst holding the unit in the operating positior_
(Fig, 3); position the J-handle to the location
that provides you the best grip.
7. Tighten the clamp screws evenly, until the J-handle
is secure,
INSTALLING THE HARNESS
WARNING: Always use the shoulder harness 1
when using the cutting blade to avoid serious I
personal injury. J
1, Push the strap through the center of the buckle.
2. Pull the strap over the cross bar and down through
the slot in the buckle (Fig. 4).
...... Fig. 4
3. Put the harness on over head and onto shoulder.
Snap it on to the support fitting (Fig. 5).
Support Fitting
Fig. 5
4. Adjust length to fit the operator's size• Pull tab to
lengthen, pull strap to shorten (Fig 6).
J_
Fig. 3 Fig. 6
8
Loading ...
Loading ...
Loading ...