Loading ...
Loading ...
Loading ...
3. Whilst holding the locking rod, loosen the nut on
the blade by turning it clockwise with a 5/8 inch
closed-end or socket wrench (Fig. 15).
NOTE: The blade retainer must be installed on the
output shaft in the position shown for the cutting
attachment to work correctly.
Cutting Attachment
Clockwise
Blade Retainer
Fig. 15
4. Remove the nut, blade retainer, and blade. Store the
nut and blade together for future use in a secure
place. Store out of reach of children.
Install the Cutting Attachment
5. Align the shaft bushing hole with the locking rod slot
and insert the locking "od into the shaft bushing hole.
(Fig, 13). Place the blade retainer on the output shaft
with the flat surface against the output shaft bushing
as shown in Fig. 16. Screw the cutting attachment
counterclockwise onto the output shaft. Tighten
securely.
Outpu_ Shaft
Bushing
Locking Rod
Fig. 16
6. Remove the locking rod.
7. install the cutting attachment shield. See Removing
and installing Cutting Attachment Shield, Pg. 9.
_ ARNING: To avoid serious personal injury,
the cutting attachment shield SHALL be in
place at all times whilst operating the unit as
a grass tdmmer,
11
Loading ...
Loading ...
Loading ...