Tripp Lite PDUMNH30HVAT2 OWNER’S MANUAL

Loading ...

LED Diagrams

HOLD HOLD

HOLD

HOLD TIME OUT

HOLD HOLD HOLD

HOLD

Control Modes

Celsius or Fahrenheit Configuration (Only Shown if EnviroSense Connected)

Note 1: Press Mode button to go to the next Display mode (vertical movement on this document). Note the Amps, kW or Volt sub-

mode will be remembered.

Note 2: Press and HOLD Enter button for 2 seconds to change the conguration. Whatever conguration is shown is what the unit

is congured for (horizontal movement on this document).

Note 3: The Active Input LEDs will always show the present source powering the load.

Note 4: Press and hold both Mode and Enter buttons for 2 seconds to show the IP address of the connected SNMP card.

Note 5: Press and hold MODE button for 2 seconds to switch to Display modes (this will go to the FIRST Display mode).

Note 6: C-F display allows the unit to be congured to display Celsius or Fahrenheit. This mode will be omitted if EnviroSense is not

connected (changes will be remembered in NVR).

Note 7: SCr Auto scroll enable or disable. When set to y (enabled), the unit will automatically scroll through Display items (See

Display modes on page 10 for details). When set to n, the unit will not automatically scroll (changes will be remembered in NVR).

Note 8: LED brightness control – Set this to 1-4 for the desired illumination intensity (changes will be remembered in NVR).

Note 9: tSt LED Test control – Press and hold Enter button for 2 seconds to initiate an LED test where all LEDs will be illuminated

for 6 seconds.

Auto Scroll Enable/Disable

LED Brightness

LED Test Control

Loading ...

Tripp Lite PDUMNH30HVAT2 5.8kW 208/240V Single-Phase ATS/Monitored PDU - 16 C13, 2 C19 & 1 L6-30R Outlets, Dual L6-30P Inputs, 10 ft. Cords, 2U, TAA