Tripp Lite PDUMNH30HVAT2 5.8kW 208/240V Single-Phase ATS/Monitored PDU - 16 C13, 2 C19 & 1 L6-30R Outlets, Dual L6-30P Inputs, 10 ft. Cords, 2U, TAA

OWNER’S MANUAL - Page 13

For PDUMNH30HVAT2. Also, The document are for others Tripp Lite models: PDUMH30AT, PDUMH30ATNET, PDUMNH30AT2, PDUMH30HVAT, PDUMH30HVATNET, PDUMH32HVAT, PDUMH32HVATNET, PDUMNH32HVAT2

PDF File Manual, 112 pages, Read Online | Download pdf file

PDUMNH30HVAT2 photo
Loading ...
Loading ...
Loading ...
Features
5
Digital LED Display and
Load Meter (Ammeter)
A
3-Digit Display: Shows measured
or calculated amperage, kilowatt
or voltage values.
B
Enter Button: Scroll through
DISPLAY and CONFIGURATION
options using this button. While in
DISPLAY mode, a short press
switches the display between
AMPS, KW and VOLTS. While in
CONFIGURATION mode, a long
press changes configuration items
(TEMPERATURE, AUTO SCROLL,
LED BRIGHTNESS). Pressing the
Enter button and Mode button
simultaneously displays the unit’s
IP address (select models).
C
Mode Button: A short press of
this button cycles through each of the modes (PRIMARY, SECONDARY, BANK,
TEMP*, HUMIDITY*) of the present category (DISPLAY or CONFIGURATION) for
both primary and secondary inputs. A long press switches between DISPLAY and
CONFIGURATION. Pressing the Mode button and Enter button simultaneously
displays the unit’s IP address (models with WEBCARDLX installed).
*TEMP/HUMIDITY only available if optional ENVIROSENSE module is attached.
D
Active Input LEDs: Indicate whether the primary or secondary active input is
powering the output.
E
2-Digit Display: Indicates whether the value shown on the 3-digit display
represents primary, secondary, bank, temperature or humidity.
Display Modes:
P: The 3-digit display is showing information related to the primary AC input. (Unit
LEDs dictate what data is shown.)
S: The 3-digit display is showing information related to the secondary AC input.
(Unit LEDs dictate what data is shown.)
b ‘n’: The 3-digit display is showing information related to the output bank number
(‘n’).
t ‘n’: The 3-digit display is showing temperature for sensor (‘n’). (Units for F or C
are configured in CONFIGURATION mode.)
h ‘n’: The 3-digit display is showing humidity for sensor (‘n’).
F
Units LEDs: The AMPS, KW and VOLT LEDs are used to illustrate the units of data
displayed on the 3-digit display.
ACTIVE INPUT
PRIMARY SECONDARY
AMP
b = BANK
t = TEMP
h = HUMIDITY
P = PRIMARY
S = SECONDARY
VOLT
KW
B
D
E
C
F
A
13
Loading ...
Loading ...
Loading ...